碩士生: 彭冠勛
畢業年月: 2020年7月
論文名稱: 甲烷/氫氣預混火焰於帶有穿透孔之不鏽鋼/鉑觸媒隔板反應器之燃燒特性研究 / Combustion characteristics of methane-/hydrogen-air premixed flames in the combined steel-platinum catalytic partition reaction with a percolated hole
中文摘要:
本研究探討以不鏽鋼—鉑隔板(含穿透孔)將微型觸媒燃燒器分為兩個流道,分別通入氫氣—空氣與甲烷—空氣混合氣時的燃燒效率與穩焰機制。模擬顯示穿透孔可提供低速流區並讓熱量與自由基在兩側流道間傳遞,使甲烷—空氣燃燒效率明顯高於傳統平板燃燒器;氫氣—空氣火焰樣態則會因穿透孔附近的溫度與速度梯度失衡而影響穩定性。研究再以Kriging模型最佳化操作與設計參數:甲烷—空氣流速影響最大,其次為孔洞位置與甲烷—空氣當量比,氫氣—空氣參數影響最小。最佳條件為甲烷—空氣當量比0.7、流速5 m/s,氫氣—空氣當量比0.9、流速10 m/s,穿透孔距燃燒底座15 mm。
英文摘要:
This thesis studies the combustion efficiency and flame-stabilizing mechanism of a micro catalytic combustor split by a stainless steel-platinum partition with a perforated hole into two channels, carrying hydrogen-air and methane-air mixtures. Simulations show that the perforated hole provides a low-velocity region and lets heat and radicals pass between channels, giving the methane-air flame a much higher efficiency than in a flat combustor; hydrogen-air flame modes affect stability through thermal and velocity imbalances near the hole. A Kriging model then optimizes the design and operating parameters. Methane-air flow rate matters most, followed by hole location and methane-air equivalence ratio, while hydrogen-air parameters matter least. The optimum is methane-air at equivalence ratio 0.7 and 5 m/s, hydrogen-air at 0.9 and 10 m/s, and the hole 15 mm from the combustor base.